Fireplaces & Stoves
Stove Thermometer, For Use On Single Wall Stove Pipe, Indicates Correct Operating Temperature.
3" x 24", 3VP-24, Pellet Stove Pipe, Model VP, Type L Vent, Tested & Listed To UL-641 Standard As Well As The UL-103 Standard.
3" x 36", 3VP-36, Pellet Stove Pipe, Model VP, Type L Vent, Tested & Listed To UL-641 Standard As Well As The UL-103 Standard.
3" x 12", 3VP-12, Pellet Stove Pipe, Model VP, Type L Vent, Tested & Listed To UL-641 Standard As Well As The UL-103 Standard.
3" x 12", 3VP-WZAJ12, Adjustable Pellet Stove Pipe, Model VP, Type L Vent, Gives Installer The Ability To Add From 2-1/2" Length To A Maximum Of 10-1/2" When Slid Over Another Piece Of Type L Pellet Pipe.
3VP-90 Degree EL, 3", 90 Degree Pellet Elbow, Model VP Type L Pellet Vent, Used To Orient Pipe Between Vertical & Horizontal Orientation, Factory Sealed At Couplers To Prevent Leakage, Fixed Elbow, Improved Performance & Nicer Seams.
3VP-EL45, 3", 45 Degree Pellet Elbow, Type L Pellet Vent, Used To Offset Pipe Around Construction Obstacles, Factory Sealed At Couplers To Prevent Leakage, Fixed Elbow, Improved Performance, Nicer Seams.
3VP-TS, 3", Pellet Vent Tee, With Tee Cap, Model VP Type L Pellet Vent, The Tee Cap Can Be Removed For Inspection & Cleanout, Used To Transition From Horizontal To Vertical Orientation, Provides Easy Access For Inspection & Maintenance.
3", 3VP-CS, Ceiling Support & Firestop, Model VP Type L Pellet Vent, Must Be Installed When Passing Through A Floor Or Ceiling In A Properly Framed Opening, Required By Most Local Codes.
3/4", 3/4VP-WS Pellet Tee Support, Model VP Type L Pellet Vent, Can Be Used To Support Either A 3" Or 4" Model VP Tee Installation.
3VP-WT, 3", Pellet Wall Thimble, Model VP Type L Pellet Vent, Must Be Used For All Thru The Wall Installations Involving Combustible Construction, Maintains Airspace Clearance, Centers Pipe Between Walls, Telescopic Design Can Be Used On Standard Walls 5" To 9" Thick.
3", 3VP-PC, Pipe Connector, Model VP Type L Pellet Vent, Used As A Starter Section To Connect The Flue Collar Of The Appliance To The Model VP Vent System.
3VP-SC, 3", Pellet Storm Collar, Used To Provide A Weather Proof Seal To Pipe Above Roof Flashing, Seal Inner Edge With Hi-Temp Silicone Sealant, Type L Pellet Pipe.
3VP-AF, 3", Adjustable Pellet Flashing, Model VP Type L Pellet Vent, Flashings Provide A Transition At The Roof Through Which The Vent Will Pass, Designed For Roofs Having A Slope Of 0/12 Flat To 6/12, Used To Waterproof Installations That Penetrate The Roof Line.
VP-VC, 3", Vertical Termination Cap, For Pellet Pipe Installations, Vent Termination For Vertical Thru-The-Roof Installations, Type L Pellet Vent, Provides Necessary Protection Of The Vent System From Rain & Other Elements.
